Users Manual Part 7

3. ADJUSTMENTS
3-14
Note 2: Select the monitor type correctly. If this
menu is set to a wide monitor ([MU-270W], [OTH-
ER(W)] or [MU-231(W)]) and no wide monitor is
connected, the screen blacks out. In this case, set
DIP switch SW2 to ON, in order to change the
monitor type to MU-190/231.
Note 3: For A/B/C/W-type radars with Radar Plot-
ter functionality, the [MU-231CR] setting is not
used.
[REMOTE MAINTENANCE]
Adjust setting for remote maintenance.
[MAINTENANCE PROFILE]: Select [ON] to output the
equipment profile for remote maintenance.
[SYSTEM MONITOR]
[DISP SYSTEM MONITOR]: Shows the system moni-
tor data through three pages. The following operations
are enabled:
F1 key: Goes to next page. After the last page, the system monitor window is not
shown.
F3 key: Saves the text data for the displayed page to an SD card.
F4 key: Saves the screen shot for the displayed page to an SD card.
[ANT CABLE]
Select the method of connection between the radar
sensor and the processor unit. [LAN] (LAN cable only)
or [LAN+COAXIAL] (LAN and coaxial cables). Select
[LAN+COAXIAL] when the optional LAN Signal Converter is installed.
[ICE MODE SETTINGS]
For the radars installed with software version *01.**”. To activate this settings, the
password is required. For the password, contact your dealer.
[RADAR]
Select radar from [MAIN] or [SUB] to activate the menu setting (default: [MAIN]).
Note: This menu is available only for the [MODEL] setting is set to [50] (see "[MOD-
EL]" on page 3-12).
DIP switchDIP switch