Users Manual Part 8

7. MAINTENANCE, TROUBLESHOOTING
7-10
(Continued from previous page)
[MAIN] [1.25V] 1.13 to 1.38 V
[1.2V] 1.0 to 1.3 V
[TEMP] -15 to +70°C
[FAN1] 3700 to 5700 rpm
[FAN2] 3700 to 5700 rpm
[FAN3] • X/S-Band radars with 24 rpm config: Not shown
• S-Band radars with 42 rpm (HSC) config: 3700 to 5700 rpm
[TB] [12V] 10.8 to 13.2 V
[3.3V] 3.0 to 3.6 V
[PWR] [P12V] 10.8 to 13.2 V
[P48V] 46 to 50 V
[P48 V CURRENT] 0 to 3 A
[MTR1] 45.1 to 51.3 V
[MTR2] • X/S-Band radars with 24 rpm config: Not shown
• S-Band radars with 42 rpm (HSC) config: 45.1 to 51.3 V
[TX HV] 500 to 570 V
RP Board (For A/B-types with Radar Plotter functionality only)
[PROGRAM No.] Shows the program version number.
[IP ADDRESS] Shows the IP address of the RP board.
[CHART MEMORY RP] OK
[USB MEMORY RP] OK
RP [1.8V] 1.6 to 2.0 V
[3.3V] 3.0 to 3.6 V
[5.0V] 4.7 to 5.3 V
[TEMP] -15 to +90°C
[FAN] 3700 to 5700 rpm
SPU (Antenna)
[PROGRAM No.] Shows the program version number.
[ROM] OK
[RAM] OK
[DIP SWITCH] Shows the DIP SWITCH settings.
[BOARD REV] Shows the revision number for each PCB.
[IP ADDRESS] Shows the IP address for the Processor Unit.
[SPU] [TX TYPE] X-12kW/X-25kW/S-30kW/S-50kW S-Solid
[12V] • Other than FAR-2x58: 11.4 to 12.6 V
• FAR-2x58: 12.2 to 13.2 V
[5V] 4.75 to 5.25 V
[3.3V] 3.18 to 3.42 V
[2.5V] 2.4 to 2.6 V
[1.8V] 1.71 to 1.89 V
[1.25V] 1.19 to 1.31 V
[1.2V_1] 1.14 to 1.26 V (not shown for FAR-2x58)
[1.2V_2] 1.14 to 1.26 V (not shown for FAR-2x58)
[1.2V] 1.15 to 1.25 V (shown only for FAR-2x58)
[3.3V_A] 3.18 to 3.42 V
(Continued on following page)
Tested item
Normal value or Description
Magnetron Radar Solid State Radar