Users Manual Part 8

6. PLOTTER OPERATION (C-TYPES)
6-62
5. Press and hold F2 to register the navigational direction to the route. The ROUTES
LIST shows the navigational direction in the upper section once registered.
6. Close the window.
Skipping waypoints
There are occasions, such as the example shown below, where you may want to skip
a waypoint without having to stop and restart navigation. You can skip waypoints with
the following procedure.
Note: This procedure requires [ROUTE DATA SOURCE] in the [ROUTE•WAY-
POINTS] menu to be set to [INTERNAL].
1. Open the menu.
2. Select [ROUTES•WAYPOINTS].
3. Select [SHOW ROUTES LIST].
4. Select the route whose waypoint you want to skip.
5. Select [RUN]. The route details appear in the [ROUTE TURN POINTS LIST].
6. Select the waypoint to skip, the press and hold F2. The waypoint and its details
appear with asterisks, as shown in the following example.
Navigational direction set to
[
FWD
]
Navigational direction set to
[
REV
]
PORT1
PORT2
New course line
WPT1
WPT2
WPT3
WPT4
WPT5
WPT6