Users Manual Part 6

Table Of Contents

3. ADJUSTMENTS

3-8

3.5.2 [OWN SHIP INFO] menu

Enter the length and width of the ship, and scanner, GPS antenna and conning posi-

tions, referring to the description and figure below.

Note: This radar uses [CONNING POSITION] for CCRP and [SCANNER POSITION]

for ANT as reference points for measurements and calculations. The commissioning

engineer should understand this point, and enter own ship information accordingly.

Open the main menu then select [RADAR INSTALLATION] [OWN SHIP INFO] to

open the [OWN SHIP INFO] menu.

[LENGTH/WIDTH]

Enter the ship’s length and width (0 to 999, default: 0).

[SCANNER POSITION]

Enter the distance from the scanner to both bow and port (0 to 999, default: 0).

[EPFS1(2) ANT POSITION]

Enter the distance from the GPS antenna to both bow and port (0 to 999, default: 0).

If a 2nd GPS antenna is installed, enter its position in [EPFS2 ANT POSITION].

[CONNING POSITION]

Enter the distance from the conning position to both bow and port (0 to 999, default: 0).

[3] Medium weak —

[4] Medium weak weak

[5] Strong Medium weak

Setting

(Effect level pattern)

Distance 1 Distance 2 Distance 3

L1: Ship length

W1: Ship width

L2: Conning position (from bow)

W2: Conning position (from port)

L3: Scanner position (from bow)

W3: Scanner position (from port)

L4: GPS antenna position (from bow)

W4: GPS antenna position (from port)

Example