Users Manual Part 6

Table Of Contents

2. WIRING

2-67

For VDR connection, the RGB signal can be output with using the optional DVI-BNC

cable kit OP03-252 (Code No.: 001-496-900).

1. Attach the five connectors of the Cable Assembly (supplied) to the fixing plate

(supplied) with cable ties as below.

2. Establish the ground system on the fixing plate.

3. Fix the cable assembly to the appropriate location with two screw (M5). The loca-

tion must be within 200 cm of the Processor Unit.

4. Connect the VDR cables to the connectors of the cable assembly.

Fastening of USB connector (for C-type radars)

The USB connector of the RP board should be fas-

tened as shown in the figure to the right. Use three

cable ties (local supply) to secure the connector of

the USB cable to the upper cable entrance of the

Processor Unit.

If there is no extra space on the cable entrance of

the Processor Unit and you can not secure the ca-

ble connector, pass the USB cable next to the thin-

nest cable (cable entrance with the most room to

spare), then pull the USB connector towards the front of the Processor Unit. Place the

USB cable beneath the other cables to prevent water intrusion into the USB cable. Se-

cure the USB cable to the neighboring cable with the supplied cable ties.

Fixing plate

Cable

Assembly

Grounding

Fix with two

M5 screws.

Cable of VDR

1. 2. 3. 4.

Cable tie

Connector of USB cable

Upper plate

USB entry