Users Manual Part 6

3-1
3. ADJUSTMENTS
Note: After completing the settings and adjustments, copy the setting data to a SD-
card* (USB flash memory* for C-type radars), referring to the Operator's Manual. This
will allow easy restoration of setting data after the MAIN Board is replaced, etc.
*: The SD card slot is in front of the Processor Unit, and the USB flash memory slot is
connected to the RP board 03P9657.
At the first start-up after installation, turn on
the Processor Unit with the main switch. Open
the protected menus to adjust the radar. Fol-
low the procedures in this chapter to complete
the adjustment.
**: For DC power specifications, the Processor
Unit does not have the main switch. To power
on the Processor Unit for DC power specifica-
tions, turn on the ship’s Mains.
For FAR-2x58 radars, turn on the Power Sup-
ply Unit also with the main switch.
Note: Turn the main switch of the Processor
Unit off before turning the Power Supply Unit
off. Further, both units should also be turned
off at the ship’s main switchboard.
Below are the controls on the Control Unit RCU-014/015(or optional RCU-016) that
are used to make the adjustments.
RCU-014
MAIN SW
Main switch**
Main switch
BRILL
EBL
F1
F3
F2
F4
OFF ON
RANGE
-
A/C RAIN A/C SEA
+
OFF
GAIN
ON
VRM
ACK
ALARM STBY
TX
TRAILS
CANCEL
TIME
VECTOR
7
CENTER
OFF
4
OFF
HL
1
BRILL
0
MODE
8
VECTOR
CU/TM
RESET
5
OFFSET
EBL
2
MODE
3
INDEX
LINE
6
LIST
TARGET
9
MARK
ENTER
CANCEL
TARGET
DATA
TARGET
ACQ
MENU
Power key
Mouse wheel
Track ball
MENU
key
Left button Right button
HL OFF key