Users Manual Part 7

2. WIRING
2-61
RW-00135/RW-00339 (for Antenna cable)
Note: For the 1.5 m of RW-00339 cable (for FAR-2x58 radars), fabrication is not re-
quired.
RW-9600/6895/4873 (for retrofit or foremast installation)
The existing cable can be used for the following cases. In these cases, the optional
LAN Signal Converter is required. See section 2.10 "LAN Signal Converter" for details.
• Cable extension for foremast installation (For X-band of FAR-2x18/2x28/2x38 ra-
dars, TR-UP radar only)
• Retrofit (For X-band/S-band of FAR-2x18/2x28/2x38 radars, TR-UP radar only)
Note: The maximum antenna cable length is 100 m for RW-9600, 50 m for RW-6895/
4873. If the existing antenna cable is longer than the above maximum length, replace
the antenna cable with RW-00135.
The unused power lines are tied up and attached to the crimp-on lug FV5.5-S4 (LF),
supplied locally. Connect these unused lines to the ground terminal with the shield
line. See the interconnection diagram at the back of this manual for details.
DPYC-2.5/6 cable (for Power)
Clamp the sheath with the cable clamp. For the supplied crimp-on lugs, use FV2-4 for
AC power cable, FV5.5-4 for DC power cable.
6
8080
1515
580580
150150
(unit: mm)
300300
100100
Outer
sheath
Armor
Vinyl tape
LAN cableLAN cable
ShieldShield
Power line
Power line
6
580580
1515
8080
Crimp-on lug
Inner shieldInner shield
Outer shieldOuter shield
Coaxial cableCoaxial cable
400400
100100
100100
Outer
sheath
Armor
Inner sheath
Vinyl tape
1414
1414
55
Folded
shield
(unit: mm)