Users Manual Part 7

2. WIRING
2-51
Connection of Power cable
1. Loosen four screws on the front plate, then unfasten two screws on the cable
clamp to set the power cable.
2. Set the power cable on the cable entrance, and fasten the sheath part of the pow-
er cable with the cable clamp. For the clamp position, see "DPYC-2.5 cable (for
Power)" on page 2-48.
3. Remove the plastic cover on TB1 to pass the power cable.
4. Connect the cable to TB1 with the pre-attached crimp-on lugs, referring to the wir-
ing label near TB1.
5. Remount the plastic cover and the front cover, then clamp the power cable on the
sheath.
TB713TB713
Motor power cable
Twist the cable.
Front PlateFront Plate
Cable clampCable clamp
Plastic coverPlastic cover
Cable entrance for power cableCable entrance for power cable
TB1TB1
Wiring label