Users Manual Part 7

2. WIRING

2-53

2. Set the heat shrinkable part of the cable for Control Unit on the appropriate lane

on the lower cable entrance, as shown below. Fasten the copper part of the cable

with the cable clamp.

3. Connect the cable for Control Unit to the connectors (TB711 and TB712) through

the appropriate wiring clamps (A) and (B).

Connection of cable for sub monitor

Up to four cables (RW-00136, RW-

4864) can be uses as sub monitor ca-

bles. Set their cables on the specified

cable entrance as shown in the figure

to the right.

1. Set the shield part of the sub monitor cables on the appropriate lanes on the up-

per/lower cable entrances as shown below. Fasten the shield part of the cable

with the cable clamp.

Clamp the

copper part.

Set the heat

shrinkable tube

on the lane.

Cable for Control Unit

TB711

TB712

(A)(A)

(B)(B)

Sub monitor cable (RW-4864/00136)

Sub monitor cable (RW-4864)