How-To Guide

2. INITIAL SETUP

1. Select a range between 0.125 and 0.25 NM and set the mode to “head up“.

You can select a range by a pinch action. The range and range ring interval ap-

pear at the bottom left of the screen.

For TZTBB, you can also control the range in the operation as follows. Tap the

radar scale box at the bottom left-hand corner of the screen to display the slider

bar. Drag the circle icon to set the range scale.

2. Turn the vessel’s bow toward a target.

3. Press the Home key (or tap the Home icon), then select [Menu] icon, [Radar], and

[Antenna Heading Align] in that order to show the numeric software keyboard.

4. Key in the offset value so that the target is at the very top of the screen (setting

range: +/- 0° to 180°, +: clockwise direction, -: counterclockwise direction), then

tap [Save].

5. Confirm that the target echo is displayed at correct bearing on the screen.

2.2 Initial Setup for TZTL12F/TZTL15F

1. Tap the [Home] icon to show the home screen and display mode settings.

2. Tap [Radar] from the [Settings] menu.

3. Tap [Radar Source], then select the appropriate antenna unit.

Note: If the antenna unit is connected but does not appear in the [Radar Source]

list, close the list and open it again. The name of the antenna unit should appear

with a check mark, as in the example below.

4. Drag the [Radar] menu display the menu item [Radar Initial Setup], then tap

[Radar Initial Setup].

5. Referring to the tables below, set up the radar.

Range Range ring interval

Range indications

Zoom outZoom in

Pinch action

Tap the area circled in the dashed line to

display the slider bar.

Note: You can switch between transmit and

stand-by by tapping the right side of the

radar scale box.

Drag the circle icon to

set the range scale.

Slider bar

Zoom in

Zoom out

4NM

Current

range

RDxxxxxx - DRS6A-NXT

Display example for DRS6A-NXT