Installation Manual

1. INSTALLATION AND WIRING
7
4. Apply adhesive to the thread holes on the bottom of the radiator (4 locations).
5. Prepare four bolt assemblies; pass the spring washer (M8) and flat washer (M8)
through the each hex bolt (M830) then apply adhesive.
6. Fasten the radiator to the radiator bracket, using the four bolt assemblies pre-
pared at step 5.
Note: Be sure to align the waveguide location between the radiator and radiator
bracket before fastening bolt assemblies.
7. Apply adhesive to the holes and bolts at the locations indicated with arrows in the
figure below. Also apply adhesive to the junction between the radiator and the ra-
diator bracket.
Bottom view: Radiator
Adhesive
Flat washer
Spring washer
Hex. bolt
Adhesive
Hex. bolt
(4 pcs)
Align the waveguide
location.
Detailed view (after securing the radiator)
Apply adhesive
to these bolts
and holes
Radiator
Bolt assembly - side view (detailed)
Apply adhesive to the
junction between the
radiator and radiator
bracket.
Apply adhesive to the
junction between the
radiator and radiator
bracket.
Flat washer
Spring
washer
Hex. bolt
Adhesive
Radiator - bottom view