Operator's Manual

2. WIRING

12. Transducer cable: Lay the transducer cable in the cable clamp then refasten the clamp fixing

plate.

Cable for the external KP: Lay the cable in the cable clamp and fix it with the supplied clamp

fixing plate and two upset screws.

13. Connect the cables as follows:

• Transducer cable: See section 2.2.2.

• Cable for external KP: See the illustration below. Pass the cable through the edge saddle

and connect the cable to J12 on the PWRTX board. Be sure the cable does not contact TB4.

Note: For cable MPYC-2, tape the vinyl sheath of the cable (approx. 6 to 7 turns) where it lies

in the cable clamp and fasten the cable clamp. The PH connector has two unused harnesses.

Cut them at their base or wrap them with vinyl tape.

Lock nut for super gland (2 pcs.)

Clamp fixing plate

Large: transducer cable

Small: cable for external KP

Edge saddle

J12

Lay vinyl sheath in

cable clamp and

fasten clamp fixing

plate (supplied).

(See step 11.)

Be sure cable does

not contact TB4.

Taping.

Cut off two unused

harnesses at base.