Operator's Manual
Table Of Contents
- IMPORTANT NOTICES
- SAFETY INSTRUCTIONS
- TABLE OF CONTENTS
- FOREWORD
- SYSTEM CONFIGURATIONS
- 1. INSTALLATION
- 2. OPERATION
- 3. MAINTENANCE,TROUBLESHOOTING
- APPENDIX 1 MENU TREE
- APPENDIX 2 VHF CHANNEL LISTS
- APPENDIX 3 PARTS LIST,LOCATIONS
- APPENDIX 4 DIGITAL INTERFACE
- SPECIFICATIONS
- PACKING LIST
- OUTLINE DRAWINGS
- INTERCONNECTION DIAGRAM
- INDEX
- Declaration of conformity
1. INSTALLATION
1-15
Continuous AIS/GPS: Output AIS/GPS data continuously. Select if interfaced
with FAISPC_MX.
Continuous AIS/ZDA: Output AIS/time data continuously. Select if interfaced
with FAISPC_MX.
Continuous GPS/ZDA: Output GPS/time data continuously. Select if interfaced
with FAISPC_MX.
Continuous AIS/GPS/ZDA: Output AIS/GPS/time data continuously. Select if in-
terfaced with FAISPC_MX.
Note: It is not necessary to change the settings of NavNet Port Number, Host
Name and AIS Data Output. Connection is available without adjusting them.
8. Click the OK button to finish.
If you changed a setting, the message below appears.
9. Click the Yes button to restart. ER LED on the FA-50 lights. After the LED goes
off access is given.
10. The message "Please close the window." appears. Close the browser.
After restart is completed, it is necessary to access the FA-50 using new values.
For example, if you changed the IP address, use the new address to access the
FA-50.
1.8.2 Ship static
Set the static data as below to use the transponder function.
1. On the Initial Setup menu, click Ship Static Edit to show the Ship Static Edit menu.
You must restart your FA-50
before the new settings will take effect.
Do you want to restart your FA-50 now?
(It will take about 1 minute to restart your FA-50)