Operator's Manual

6. WEB FUNCTIONS
6-37
How to show the PPPoE status monitor display
The PPPoE status monitor display shows the packet communication volume for the
current PPPoE session.
1. Start the Internet Explorer
®
and connect to the internet with PPPoE as shown in
the procedure on page 6-35.
2. Enter http://192.168.254.1 in the address bar then press the [Enter] key to show
the PPPoE status monitor display.
6.1.11 How to set the Bridge mode
The Bridge mode uses the global IP address assigned by Inmarsat to communicate
via the specified LAN port on the user terminal. The user terminal can not set the NAT
or Firewall.
Note 1: Set Firewall and traffic limitation at the user’s network device.
Note 2: The Bridge mode settings must be done by the network administrator.
1. Click [Settings] in the menu bar.
2. Click [Network settings].
3. Click [Bridge mode].
4. Click the [Add bridge] button.
5. Set as follows:
Item Description
Port • Select LAN port (LAN1, LAN2, LAN3, LAN4).
• LAN port already used can not be selected.
Connection • Constant connection: Put a [9] in the checkbox beside [Al-
ways on].
• Irregular connection: Remove the checkmark beside [Al-
ways on.]
No. of registrations/No. of registrations available