Operation Manual

16
3.7 Adjusting Loudspeaker
Volume
The loudspeaker can be adjusted by pressing [ ] or [ ]
adjust volume. The setting range is 00-10, with three
sub-levels between each main levels. Each pressing of
[
] or [ ] key changes the volume, however the volume
indication changes only when reaching a next whole
number. For example, if the current volume setting is
main level 01, you would need to press the [up] key
three times to reach main level 02.
Note: Only Remote 1 is available.
3.8 Muting the Loudspeaker
1. The handset automatically mutes the loudspeaker
when the PTT switch is pressed, provided the
speaker is active, and then reactivates the
loudspeaker when the PTT switch is released.
2. To mute the loudspeaker, press the [
] key over one
second to show “OFF” next to indication “VOL”.
Repeat the procedure to activate the loudspeaker.
3.9 Setting Transmitter Power
1. You can control the transmitter power level at the
handset, which can be set to either 1 W or 25 W.
Low and high power are shown on the display as 1W
and 25W. Note that some channels are programmed
to operate at 1W only. See the list at the back of this
manual.
2. To change the transmitter power, press the [H/L] key
over one second to show 1W or 25W on the display.
3.10 Receiving a Telephone Call
When a call arrives your call name is heard in the
loudspeaker.
1. Hook off the handset.
2. Press the PTT switch on the handset.
3. To answer the call say
a) The name of the calling station
b) Your station name
c) Suggested channel number
d) Over.
Example: Voyager, This is FURUNO, Channel 06,
Over
4. Release the PTT switch.
5. Switch to channel agreed upon and communicate.
For close-range communication use 1 W transmitter
power.
6. Press the PTT switch to talk: release it to listen. If
you are using a simplex channel (Tx and Rx
frequencies are the same) say “over” every time you
have finished talking