Operation Manual

41
Appendix
How to fabricate the cable for optional connector 17JE-23250-02/17JE-23090-02
When connecting the optional handset for REMOTE2 and/or navigational equipment to port IEC 61162-1 (NMEA),
optional connector 17JE-23250-02 (for handset)/17JE-23090-02 (for NMEA) and appropriate cable are required.
Fabricate them as below.
1. Remove the vinyl sheath.
2. Unravel and cut the aluminum tape at appropriate
location.
45
3
Vinyl sheath
Twist and trim the drain.
Aluminum tape
Remove the vinyl sheath by 45 mm.
Remove the aluminum tape by 10 mm,
and the sheath of the cores by 3 mm.
Fabrication of 05S0308 (for REMOTE2)
10
3. Wrap copper tape around sheath once.
4. Fold back aluminum tape onto copper tape.
5. Continue wrapping copper tape around cable.
6. Remove insulator of all cores for about 4 mm, and
presolder the tip of each wire.
7. Solder the cores to the connector pins referring to the
schematic diagram at back of the operator’s manual.
8. Assemble the connector.
Supplied rubber tube is not used.
Aluminum tape
and copper tape
Cable clamp
Cable