Operation Manual

1-7

User channels

You can recall user channels through the keyboard by channel numbers. Once a channel is

selected with the keyboard, the channel can be changed with the [FREQ/CH] control.

For how to write user channels, see Chapter 3. 199 user channels ( 0-01 to 0-99 and 1-00 to 1-

99) can be programmed in addition to ITU channels.

To call the channel 1-20, for example:

Tx only

Press [TX], [CH], [1], [2], [0], [ENT]

RX only

Press [RX], [CH], [1], [2], [0], [ENT]

TX and RX paired

Press [CH], [1], [2], [0], [ENT]

Note: The standard sets provide readout of Rx CH No. and Rx frequency in kHz. When trans-

mitting, Tx CH and Tx freq. are displayed. Pressing the [ENT] key displays both Tx and Rx

frequencies.

6810

LOW

J3E

AGC NB SWEEP

SIMP

—

Rx band

Rx CH

Frequency

Figure 1-5 Sample user channel (Rx)

• The [CURS/2] key shifts the cursor to band or channel number.

• To change channel number use the [FREQ/CH] control; it changes the number above the

cursor, a band or channel designator.

• The [ENT] key temporarily displays both Tx and Rx frequencies.