Marine GPS System User Manual

6-1
6.1 Entering Marks
You can inscribe marks on the plotter display
to denote important locations; for example,
buoy, fishing point, wreck, etc. Further, marks
can be connected with lines to depict an area
such as a hot fishing spot.
100 marks may be entered. When the mark
memory is full the oldest mark is deleted to
make room for the latest.
Entering a mark at ship's position
1. Press the CURS key to turn off the cur-
sor.
2. Press the EVENT MOB key. The mark
currently selected on the TRACK/MARK
SETUP menu appears at own ship's posi-
tion.
Entering a mark at cursor intersection
1. Press the CURS key to turn on the cursor.
2. Press the EVENT MOB key. The mark
currently selected on the TRACK/MARK
SETUP menu appears at the cursor inter-
section.
6.2 Entering Event Marks
The event mark denotes a point of interest at
own ship’s position.
100 event marks may be entered. When the
event mark memory is full the oldest event
mark is deleted to make room for the latest.
Enabling entry of an event mark
To enable entry of an event mark do the fol-
lowing:
1. Press the MENU key.
2. Press the [0] key to select SYSTEM
MENU.
SYSTEM MENU
1. SELF TEST
2. PLTR SETUP
3. SOUNDER SETUP
4. UNIT SETUP
5. SENSOR SETUP
6. NMEA SETUP
7. GPS SETUP
8. DGPS SETUP
9. CHART POSN CALIB
: Cursor
ENT: Sel ESC: Esc
Figure 6-1 System menu
3. Press the [2] key to select PLTR SETUP.
PLTR SETUP
NAVAID
SCALE
SMOOTHING
SPD AVERAG
BEARING
MAG CALIB
EVNT METHOD
POSITION
DISP
Chain: Sec
LOP CALIB
OWN LC DE ALL
SCALE RANGE
00 (00~15)
00 min
TRUE MAG
AUTO MAN
06.3°W 00.0°E
EVENT MARK
L/L LOP
LC DE
7970: 11-26
+000.0 µs
+000.0 µs
: Cursor ESC: Esc
: E/W, +/-
Figure 6-2 Plotter setup menu
4. Press ▼ or ▲ to select EVNT METHOD.
5. Press t to select EVENT.
6. Press the MENU key.
Entering an event mark
Press the EVENT MOB key. An event mark
is entered at own ship's position.
MARKS