Marine GPS System User Manual

3-2
DGPS port
1. Press the [MENU] key.
2. Press the software key labeled "CONFIGURATION".
3. Press the software key labeled "SETUP NMEA/DGPS PORT 2".
4. Select "FORMAT" by the arrow key.
5. Press the software key labeled "EDIT" to display the following message.
s FORMAT NMEA 0183
VER 1.5
▲▲▲
OUTPUT FORMAT
NMEA0183 Ver1.5
' NMEA0183 Ver2.0
RTCM104 (EXTRN)
RTCM104 (INTRN)
DGPS 3D
SETUP
PORT2
ENTER
CANCEL
▼
▲
RTCM104 (OUTPUT)
Figure 3-2 Output Format Display, DGPS port
6. Select NMEA version, external DGPS or internal DGPS by the arrow key.
NMEA0183 Ver1.5/Ver2.0 : Select one when connecting PC or RS-232C
equipment.
RPCM104(EXTRN) : Select this when connecting external DGPS
beacon receiver.
RTCM104(INTRN) : Select this for builtin internal DGPS beacon
receiver.
RTCM104(OUTPUT) : Select this when outputtig differential data of
the internal DGPS beacon receiver to other
GPS navigator.
Note 1)You cannot setup sentences when you select RTCM104 as the format.
Note 2) For RS-422 format, the level converter (IF-1432) is required for connection
of external equipment.
7. Press the software key labeled "ENTER".
8. Press the [PLOT] key to finish.