Marine GPS System User Manual

4-3
Installation of DGPS receiver
Procedure
1. Dismount chassis assembly from panel/chassis assembly by disconnecting the
connector and PH8P from J8 on MAIN Board shown in the figure below.
Chassis Assembly
Connector
Panel Assembly
PH8P
Remove two ties (CV-100).
Figure 4-2 Dismounting chassis assembly
2. Dismount heat sink from chassis assembly by unfastening three screws on the
ANLG board, loosening a screw at TR fixing plate and disconnecting the con-
nector of the mini pin coax cable.
ANLG Board
Screws (3 X 8), 3pcs.
Mini pin coax cable
Heat Sink
TR fixing plate
Figure 4-3 Chassis assembly