User manual

ManualsBrandsFuruno ManualsOtherMarine Instruments 711c

TABLE OF CONTENTS

5.5.1 Message pop-up display .............................................................................. 5-12

5.5.2 Message board ............................................................................................ 5-13

5.5.3 Message description .................................................................................... 5-13

5.6 Sensor in Use Display.............................................................................................. 5-16

6. INSTALLATION AND WIRING ..............................................................................6-1

6.1 Installation .................................................................................................................. 6-1

6.1.1 Installation location......................................................................................... 6-1

6.1.2 When FAP-7011 is replaced with FAP-7011C............................................... 6-2

6.1.3 How to install the control unit ......................................................................... 6-3

6.2 Wiring ......................................................................................................................... 6-5

6.2.1 Wiring notices................................................................................................. 6-6

6.2.2 Connection with the processor unit................................................................ 6-7

7. INITIAL SETTINGS ................................................................................................7-1

7.1 How to Select Language and Units, Open the Installation Menu Window ................. 7-1

7.2 Display Setup ............................................................................................................. 7-3

7.3 Ship’s Characteristics Menu....................................................................................... 7-4

7.4 Dockside Setup Menu ................................................................................................ 7-5

7.4.1 Dockside setup for the rudder reference unit................................................. 7-5

7.4.2 Dockside setup for Fantum Feedback

..................................................... 7-11

7.4.3 How to set the safe helm mode and power assist mode.............................. 7-15

7.4.4 Confirmation of the dockside setup.............................................................. 7-19

7.5 CAN bus Port Setup................................................................................................. 7-23

7.6 NMEA0183 Port Setup............................................................................................. 7-25

7.7 Sensor Setup ........................................................................................................... 7-27

7.8 Universal Port Setup ................................................................................................ 7-28

7.8.1 GENERAL IN port setup .............................................................................. 7-28

7.8.2 GENERAL OUT port setup .......................................................................... 7-29

7.9 Sea Trial................................................................................................................... 7-30

7.9.1 How to calibrate the compass (PG-500/PG-700)......................................... 7-31

7.9.2 How to set the rudder deadband.................................................................. 7-33

7.10 Data Calibration ....................................................................................................... 7-34

7.11 Parameter Setup Menu ............................................................................................ 7-35

7.11.1 Sea state...................................................................................................... 7-35

7.11.2 Trim gain ...................................................................................................... 7-38

7.11.3 Speed calculation......................................................................................... 7-39

7.12 AUTO Option Menu.................................................................................................. 7-39

7.13 NAV Option Menu .................................................................................................... 7-40

7.13.1 How to select the source for nav data.......................................................... 7-41

7.14 Fish Hunter Option Menu ......................................................................................... 7-42

7.15 Wind Option Menu ................................................................................................... 7-43

7.16 System Setup Menu................................................................................................. 7-44

7.17 RC (Remote Controller) Setup Menu ....................................................................... 7-45

7.18 All Clear (Default Setting)......................................................................................... 7-45

APPENDIX 1 MENU TREE .......................................................................................AP-1

APPENDIX 2 JIS CABLE GUIDE .............................................................................AP-6

SPECIFICATIONS .....................................................................................................SP-1

PACKING LIST ............................................................................................................ A-1

OUTLIBE DRAWING ................................................................................................... D-1

INTERCONNECTION DIAGRAM ................................................................................ S-1

INDEX.......................................................................................................................... IN-1