Operator's Manual

1. OPERATIONAL OVERVIEW
1-7
1.6 SD Cards
The SD card stores the tracks, routes, points, settings, etc. Set and
remove SD cards as shown below. The recommended capacity for
the cards is 128 MB to 2 GB. (The Secure Digital High Capacity
(SDHC) SD cards cannot be used.)
How to format an SD card
You do not normally need to format an SD card for use with the system. If the card
becomes damaged, format the card with a formatting program that is compatible with
the specifications of the SD card. The SD Memory Card Formatting Software made by
Panasonic is an example.
How to set an SD card
1) Pull down on the tab on the card drive
cover to open the card drive.
2) As shown in the right-hand figure, put the
SD card in either card drive with the label
up. If the card does not set easily, do not
use force.
3) Push the card until the card is in position.
How to remove an SD card
1) Pull the tab on the card drive cover to
open the card drive.
2) Push the card to release the card from
the card drive.
3) Remove the card with your fingers then
close the cover.
About the SD cards
• Use SD cards carefully. Wrong use can
damage the card and destroy its contents.
• Make sure the cover is closed at all
times.
• Remove a card with only your fingers. Do
not use metal instruments (like tweezers)
to remove the card.
• Do not remove a card during the reading
of the card or writing to the card. The pow-
er LED flashes when the system accesses
an SD card.
• If there is water at the bottom of the card cover, DO NOT open the cover. Re-
move the water with a dry cloth completely and then open the cover.
Control Unit
MCU-001
OUT
IN
RANGE
DISP MENU
GAIN
TX
CTRL
SAVE
MOB
B
R
I
L
L
SHIP
3D
S
C
R
O
L
L
I
N
Display Control
Unit DCU12