Operator's Manual

3. 3D DISPLAY, OVERLAYS
3-2
How to activate and deactivate the aerial view by the SHIP/3D button
Before you do this procedure, open the [Chart-General] menu and activate [3D Pan/
Tilt Mode]. This sequence allows you to adjust the pitch and orientation.
1. Long-push the SHIP/3D button to start the 3D display.
2. Rotate the RotoKey to adjust the pitch, i.e., the vertical angle of view. The range
of adjustment is 1-90°.
3. Push the RotoKey to validate the setting.
4. Rotate the RotoKey to rotate the picture, from 0-360°.
5. Push the RotoKey to validate the setting
Another method is to use the CursorPad to adjust the display. Use S and T to adjust
the pitch and W and X to set the orientation. After you set the pitch and orientation,
press the left-click button or push the RotoKey.
To readjust the display, first long-push the RotoKey and select the [3D] and [3D Pan/
Tilt] soft controls. Readjust the display as shown in the above procedure.
To return to the 2D display, long-push the SHIP/3D button.
How to activate and deactivate the aerial view with the soft controls
1. Long-push the RotoKey.
2. Select the [3D] and [3D Pan/Tilt] soft controls. (You can also activate the display
if you select the [Aerial View] soft control. Push the RotoKey to select the [3D
Pan/Tilt] soft control.)
3. Adjust the display with the RotoKey, following steps 2-5 in the above procedure.
To readjust the display, long-push the RotoKey then select the [3D] and [3D Pan/Tilt]
soft controls.
To restore the 2D display, push the RotoKey and select the [3D] and [2D View] soft
controls.