Instruction Manual

2.3.
Copy the “ucpool.uc” to the root of an SD-Card (the file should not be inside a folder).
Transfer the Unlock Code file
Insert the SD-Card on any MFD. The following message will appear after a couple of
seconds:
Every chart that was “Locked” will be automatically unlocked.
Repeat this process on every MFD.
Note: you can also copy a chart on the same SD-Card. In this case, after the message
appears, simply launch the chart copy process from the “Data Catalog” tab (“Install
Data” button) under the “Chart” menu.
Warning:
Remember to repeat this process on ever MFD in the NN3D system.
If the charts are not Unlocked after inserting the SD-Card (and after the
message above appears), make sure that you downloaded the correct “ucpool.uc” file
corresponding to the SystemID. If you made a mistake simply repeat the process with
the correct “ucpool.uc” (this will overwrite the incorrect “ucpool.uc”)
END.