Installation Instructions

Before you do it your way,
please try it our way
TELEFLEX CANADA
3831 NO.6 ROAD
RICHMOND, B.C.
CANADA V6V 1P6
FAX [phone]
www.seastarsteering.com
© 2005 TELEFLEX CANADA LIMITED PARTNERSHIP
PRINTED IN CANADA
FORM NO. 269064 - 03/06 Rev C
ISO 10592
INSTALLATION INSTRUCTIONS
SUPPLEMENTAL
20
Autopilot Rudder Reference
SMART
STICK
ISO 9001
MANUFACTURED BY
TELEFLEX CANADA LIMITED
PARTNERSHIP
HYDRAULIC
INSTALLATION INSTRUCTIONS
1 Remove the nuts and washers
(item 1 & 2) from the steering
cylinder rod. Discard washers
(item 2) as they will not be used
in the SmartStick installation.
2 Install brackets (item 3) onto the
ends of the cylinder support rod.
Re-install the nuts (item 1) and
torque to 33 in. lb. (3.82 Nm).
3 Install the sensor (item 4) behind
the brackets as shown in figures
A and B.
4 Mount the magnet (item 5) to the
center of the cylinder body with the
arrow pointed in the same direction
as the arrow on the sensor.
5 Turn steering cylinder so that the
magnet arrow and the sensor decal
arrow are nearest each other.
6 Without changing the position
along the length of the cylinder,
rotate the magnet on the cylinder
so that the arrows on the sensor
and magnet are as closely lined
up as possible.
7 Tighten band clamp to 3 in. lb.
(0.35 Nm) to secure the magnet
in position.
Correct installation of the magnet
is important to the overall
operation of the autopilot.
Over tightening clamp may cause
magnet to break.
8 Connect Rudder Reference to
autopilot as per autopilot instal-
lation instructions. Refer to Table
1 to ensure correct application
9 Move the steering cylinder from
hard over to hard over to confirm
that the autopilot receives a
signal from the sensor at ALL
cylinder positions.
10 Install Strain relief (item 6).
Failure to install the strain relief
may result in irreparable damage
to the sensor.
NOTICE
NOTICE
NOTICE
TOOLS REQUIRED
5/8" Wrench 5/16" Wrench
11/32" Wrench 3/32" Allen Key
Torque Wrench