Installation Instructions

Mixed TZtouch MFD & NN3D MFD Network Installations:
(5)
FURUNO U.S.A., INC.
Camas, WA
[phone]
Denton, MD
[phone]
NavNet TZtouch Installation Checklist
Make sure the NN3D network is fully operational.
(We strongly recommend
that you update any existing NN3D MFDs with the latest software before
integrating a new TZtouch MFD into a NN3D Network)
.
Connect the TZtouch to the NN3D Ethernet network.
Note: Leave the HUB101 Dip Switch setting to OFF on the port(s) used to connect
TZtouch MFDs.
IMPORTANT: Do NOT connect any TZtouch MFDs to the NMEA2000
backbone! Only the NN3D MFDs are connected to the NMEA2000
backbone(s) in a mixed network!
If charts were purchased for the NN3D network, set one TZtouch MFD as Chart
Master (from the “Initial Setup” menu), then communicate with NavNet3D
SystemID (SI…..) and TZtouch SystemID (N4…) to Furuno USA. Furuno
USA will link the NN3D and TZtouch SystemIDs in our www servers. This
will generate new unlock codes for the TZtouch MFDs from the existing NN3D
unlock codes. This is a free service provided by Furuno USA.
Proceed to the Unit adjustments from the “Units” menu.
Proceed to the Time Offset adjustments using the “Time Offset” drop down of
the “General” menu.
If a Sirius Satellite Weather Receiver is installed in the Network (BBWX1 or
BBWX2), set the “Weather Data Server” to “Sirius” from the “Weather” menu.
IMPORTANT: All NavNet TZtouch installations are REQUIRED TO HAVE
AN APPROPRIATE HEADING SENSOR CONNECTED TO THE SYSTEM.