Instruction Manual

Connecting the LED Wires Directly
If you do not install the recommended remote control, you can set the static color of the LEDs by connecting
the color LED wires to the negative (-) terminal of a 12Vdc power source. You can splice the negative (-) wire to
multiple LED wires to customize the LED color and tone. You must connect the black LED wire to the positive (+)
terminal of the same power source to complete the circuit.
You should use a water-tight connection method when connecting the LED wires. You can use crimp connectors
instead of solder and heat-shrink if the crimp connectors can be routed through the bracket and the wake tower
or your mounting location, so you should plan and select the best connection type for your installation needs.
You should use 20AWG (0.5 through 0.75mm
2
) or thicker wire to connect the LED wires to the battery.
You should use a water-tight connection method when connecting wire to the LED wiring harness.
You must connect the positive (+) wire (black) for all of the speaker LEDs to a 3A fuse near the power-source.
You should also connect the positive (+) power wire to the power source through an isolator switch or circuit
breaker to turn the LEDs on and off. You can use the same isolator or circuit breaker controlling the power
supply to your stereo, which allows you to turn the LEDs and the stereo on and off at the same time.
1 Connect the black wire on the LED cable to the positive (+) terminal of the power source .
NOTICE
To avoid damage to the speakers or the vessel, you must connect this wire through a 3A fuse near the
power source.
2 Connect the negative (-) wire from the same power source to one or more color wires on the LED cable
according to the preferred LED color.
NOTICE
You must insulate any unused LED wires to avoid causing a short circuit.
LED Color LED Wire Color
Red Red
Green Green
Blue Blue
Yellow Red and green
Magenta Red and blue
Cyan Blue and green
Cool white Turquoise
Warm white Yellow
NOTE: You can connect the cool white or warm white wire to change the tone of any LED color combination.
3 Repeat for other speakers, as needed.
Speaker Information
True-Marine
™
Products
True-Marine products are subjected to rigorous environmental testing under harsh marine conditions to surpass
industry guidelines for marine products.
Any product that bears the True-Marine stamp of assurance has been designed for simplicity of use and
combines advanced marine technologies to deliver an industry leading entertainment experience. All True-
Marine products are supported by the Fusion 3-year worldwide limited consumer warranty.
4