Instruction Manual

Table Of Contents

Cleaning the Speakers

NOTE: When mounted correctly, these speakers are rated IP65 for dust and water ingress protection under

normal conditions. They are not designed to withstand high pressure water spray, which may occur when

you wash down your vessel. Failure to carefully spray-clean the vessel may damage the product and void the

warranty.

NOTICE

Do not use harsh or solvent-based cleaners on the speakers. Using such cleaners may damage the product and

void the warranty.

1 Clean all salt water and salt residue from the speaker with a damp cloth soaked in fresh water.

2 Use a mild detergent to remove a heavy buildup of salt or stains.

Troubleshooting

Before you contact your Fusion dealer or service center, you should perform a few simple troubleshooting steps

to help diagnose the problem.

If the Fusion speaker has been installed by a professional installation company, you should contact the

company so the technicians can assess the problem and advise you about possible solutions.

There is no sound coming from the speakers

• Verify that all connections from the source device and/or the amplifier are connected correctly to the speaker

terminals.

The system lacks bass or high frequencies

• Verify that the correct wire polarity is observed between the source and speakers.

The wires should be connected positive to positive and negative to negative.

• Verify that the speakers are attached firmly to the mounting surface.

The audio is distorted

• Verify that the source volume is not too loud for the speaker, and reduce the volume if necessary.

• Verify that the panels surrounding the speaker on the vessel are not rattling.

• Verify that the source device and/or the amplifier are connected to the speaker terminals correctly.

• If the speaker is connected to an amplifier, verify that the input level of the amplifier is matched to the output

level of the stereo. For more information, see the manual for the amplifier.

The LED lights will not turn on

• Verify that all wiring connections are correct and tight.