Owner's Manual

8
Using the installation instructions provided with the FUSION
Waketower Can speakers, connect the speaker and LED
wires.
9
Feed the connected wires through the pass-through hole and
grommet into the waketower pipe.
10
Place the top of the bracket over the pipe , and hold it
against the base of the bracket.
11
Attach the top of the bracket to the base of the bracket using
the included screws with a 6 mm hex driver or hex key.
12
Repeat these steps for additional brackets.
Adjusting the Angle of the Speaker
1
If necessary, loosen the lock screw on the side of the
bracket using a 4 mm hex driver or hex key.
2
Adjust the angle of the speaker.
3
Tighten the lock screw.
Specifications
Material Bracket: aluminum alloy
Grommet: silicon
Spacer: plastic
Supported
waketower pipe
sizes
33.4 mm (1.31 in.), 42.2 mm (1.66 in.), 48.3 mm
(1.90 in.), 50.8 mm (2.00 in.), 57.2 mm (2.25 in.),
60.3 mm (2.37 in.), and 63.5 mm (2.50 in.) outer
diameter using the included spacers
Bracket Side Dimensions
174 mm (6
7
/
8
in.)
120 mm (4
3
/
4
in.)
Bracket Top Dimensions
52 mm (2
1
/
16
in.)
Installation Instructions 3