Instruction Manual

Attaching the Grille to the Classic Model Speakers
NOTE: This feature is available only on the Classic model speakers.
1 With the speakers mounted, hold the grille with the Fusion logo at the bottom, or at the 6o'clock position.
2 Turn the grille counter-clockwise about 10°, so the Fusion logo is at the 5o'clock position.
3 Place the grille on the rim of the speaker.
4 Twist the grille clockwise to secure it.
Speaker Wiring
When connecting the speakers to your stereo or amplifier, observe these considerations.
• The wires on each speaker are terminated using a connector, and you should use the provided wiring
harnesses when connecting the speaker wires to the stereo or amplifier.
• Speaker wire is not included. You should use 16 AWG (1.3 through 1.5mm
2
) or larger speaker wire to
connect the wiring harness to the amplifier.
• You should use a water-tight connection method when connecting speaker wire to the wiring harness.
You can use this table to identify the polarity of the wires on the provided harnesses.
Lead color Polarity
White Positive (+)
White with a black stripe Negative (-)
LED Wiring
NOTICE
Using certain LED colors on the speakers, such as red and green, may violate the laws, regulations, and
standards related to the use and/or operation of marine navigation lights. It is the user's responsibility to
comply with any such applicable laws, regulations, and standards. Garmin is not responsible for any fines,
penalties, citations, or damages that may be incurred due to any such lack of compliance.
It is recommended to install a Fusion CRGBW Wireless Remote Control module with these speakers to turn the
LEDs on and off, change the colors, and create lighting effects. See your Fusion dealer or garmin.com for more
information.
The LED wires on each speaker are terminated using a connector, and you should use the provided wiring
harnesses when connecting the LED wires to a CRGBW Wireless Remote Control module or power source.
NOTE: LEDs are not available on all models.
4