Owner's Manual

General Settings
Select , select the name of the remote control, and select SETTINGS.
NOTE: If you select the name of the currently-controlled stereo before you select SETTINGS, you can adjust
the settings of the stereo instead of the remote control.
When a stereo is in a group, you cannot change settings on that stereo.
The following setting descriptions apply to the remote control only. For information about stereo-specific
settings, see the stereo owner's manual.
DEVICE NAME: Assigns a name to the remote control for better identification on the network.
LANGUAGE: Sets the language used on the remote control.
POWER OPTIONS > POWER SAVE: Disables the LCD backlight after one minute of inactivity to save battery
power.
ASSIGN HOME ZONE: Assign the default zone on a connected stereo for the remote control.
NETWORK: Adjusts network settings (Network Settings, page 8).
UPDATE: Update or reset the remote control (Update Options, page 8).
ABOUT: Shows the software version for the remote control.
Update Options
Select , select the name of the device, and select SETTINGS > UPDATE.
ERX REMOTE: Updates the remote control from a stereo connected to the ETHERNET port or the Fusion
PartyBus network using a valid software update file on a USB flash drive connected to the stereo (Software
Updates, page 9).
FACTORY RESET: Restores all settings to the factory default values.
Network Settings
Select > SETTINGS, select the name of the remote control, then select NETWORK.
DHCP CLIENT: Sets the device as a DHCP client. This is the default setting for all devices that are not
configured to be a DHCP server.
STATIC IP: Allows you to set a static IP address for the device (Setting a Static IP Address, page 9).
GARMIN MARINE NETWORK: Allows the device to be used on a Garmin
®
Marine Network so it can be viewed
and controlled by connected Garmin chartplotters.
RESET: Resets the network configuration on the remote control to factory defaults.
DETAILS: Shows information about the network configuration.
SAVE: Allows you to save changes to the network settings.
Setting the Device as a DHCP Client
This device is set as a DHCP client by default. When set as a DHCP client, the device is configured for use on
a network with a DHCP server. If no DHCP server is present on the network, the device assigns its own local IP
address after a short delay.
NOTE: Although the Fusion PartyBus devices can communicate with each other without a DHCP server on the
network, the devices take longer to connect to each other when you first turn them on. It is highly
recommended to have one properly-configured DHCP server on the network for the best results.
1 Select > SETTINGS.
2 Select the name of this device.
3 Select NETWORK > DHCP CLIENT > SAVE.
8 General Settings