Installation Instructions

202020

2 CHANNEL AMPLIFIER

1 POWER AND STATUS LED’S:

This displays ‘Green’ if the ampliﬁer has been correctly powered up and ‘Red’ if any faults are present.

2 CROSSOVER SELECTOR:

Set the appropriate mode of operation. The three positions available are OFF, LP and HP.

See points 3 and 4 below.

3 LOW PASS:

Set the crossover switch 2 to LP when a subwoofer is connected. Ensure the crossover frequency is

set at 100Hz or below, this feature is designed to ﬁlter out all mid to high frequencies that only full range

speakers should produce.

Note: Failure to do so could result in speaker damage.

CONTROL DESCRIPTIONS

NV-AM10002

13 14

1 2 3 4 7 8 9 5