User Manual

Initial Set-Up

(Set-Up Procedure When Installed In a Car)

When installing the servos in a car, performing function set-up in the following order

is recommended.

1. Set up the servo trims (page 22).

2. Set the servo direction of operation using the Reverse

function. (Page 47)

The servo installation method and linkage direction depend

on the kit. Therefore, the servo operation direction may have

to be reversed relative to transmitter operation. Before in-

stalling the servo, check the operating direction and set it us-

ing the Reverse function.

3. Set the subtrim and adjust the servo neutral point. (Page

46)

4. Set EPA of each channel and adjust the servo throw

(travel). (Page 30)