Instruction Manual
23
TRANSMITTER DISPLAYS & BUTTONS
reversed, and travels and trims will be wrong, potentially leading to a crash.
JOG KEY:
Control JOG KEY to scroll up/scroll down/scroll left/scroll right and select the option to edit within a
function. When the menu has multiple pages, move the JOG KEY horizontally (left or right).
Press JOG KEY to select the actual function you wish to edit from the menu.
Press JOG KEY and hold one second to confirm major decisions, such as the decision to: select a
different model from memory, copy one model memory over another, trim reset, store channel position
in FailSafe, change model type, reset entire model, condition of a helicopter setup is changed. An on
screen inquiry will ask if you are sure.
Press JOG KEY again to accept the change.
＋
KEY:
Press and hold
＋
KEY for one second to open programming menus. It uses for change of a setup, or a
numerical increase. Change of the page of a menu can also be performed.
−
KEY:
It is used for change of a setup, or reduction of a number. Change of the page of a menu can also be
performed.
END BUTTON:
Press END BUTTON to return to previous screen. Closes functions back to menus, closes menus to
start-up screen.
Rudder trim
display
Aileron trim
display
Timers
Throttle trim
display
Model number
and name
Jog key
END
Key
Total timer display <TIMER>
Shows the cumulated ON time. (hours:minutes)
Up/down timer display <ST1.ST2>
(minutes:seconds)
Model timer display <MDL>
Shows the cumulated ON time for each model.(hours:minutes)
System timer display <SYS>
Shows the cumulated ON time.(hours:minutes)
Resetting timers:
Select the desired timer with JOG KEY. The timer display
flashes. To reset the timer, press JOG KEY.
Elevator trim
display
Battery
voltage
4CELL TYP 5CELL TYP
System
ࠉ"S-FHSS" "FHSS"
Model type
Output display
−key
＋key