Instruction Manual
27
A LOOK AT THE RADIO'S FUNCTIONS STEP BY STEP
MODEL SELECT
submenu: includes three functions that manage model memory:
MODEL SELECT
,
MODEL COPY
and
MODEL
RESET
. Since these functions are all related, and are all basic features used with most models, they are together in the
MODEL SELECT
submenu.
NOTE: When you choose a new model in the
MODEL SELECT
function, if the new
model is set to a different modulation, you must cycle the transmitter power to change
screen to remind you. Please note: You are still transmitting on the other modulation
until you affect this change.
GOAL: STEPS: INPUTS:
Select Model #3.
NOTE: This is one of several
functions for which the radio requires
Open the menu, then open
MODEL
SELECT
submenu.
for 1 second.
if required to
MODEL SELECT
.
Choose Model #3.
to
3
.
for 1 second.
Sure?
displays.
Close.
Confirm proper modulation of new
model memory.
If
SFHSS/FHSS
is set for the other receiver type. Turn the transmitter off/on to change the
modulation.
Where next?
MODEL NAME
the model: see p. 29.
Change
MODEL TYPE
(aircraft, heli): see p. 30.
Change modulation (
SFHSS
or
FHSS
): see p. 31.
Utilize servo
REVERSE
: see p. 35.
Adjust
END POINTs
: see p. 36.
Set up
IDLE-DOWN
and
THR-CUT
for throttle management: see p. 37, 38.
MODEL SELECT
: This function selects which of the 20 model memories in the
are indicated after its number. (Each model memory may be a different model
type from the other memories.)
MODEL
COPY
: copies the current model data into another model memory in the transmitter. The name of the model memory
you are copying into is displayed for clarity.
Notes:
type and modulation. Upon completion, it cannot be recovered.
Examples:
airplane model at extreme altitudes).