Instruction Manual
28
GOAL of EXAMPLE: STEPS: INPUTS:
Copy model 3 into model 5.
NOTE: This is one of several
functions for which the radio requires
Open the menu, then open
MODEL
SELECT
submenu.
for 1 second.
if required to
MODEL SELECT
.
Confirm you are currently using the
proper model memory. (Ex: 3)
If
SELECT
does not indicate
3
, use
MODEL
SELECT
, p. 27.
Go to
MODEL
COPY
and choose the
model to copy into. (Ex: 5)
to
COPY
. to
5
.
for 1 second.
Sure?
displays.
*
Close.
Where next?
SELECT
the copy you just made: see p. 27.
Rename it (it is currently named exactly the same as the model copied): see p. 29.
*Radio will show "complete" and it shows that the copy was completed. Note that if the power switch is turned off prior to completion, the data will
not be copied.
MODEL
RESET
.
MODEL
RESET
you can accidentally delete all models in your radio with this function. Only a service center can completely reset your
SELECT
each model, reset that memory, then go
SELECT
the next memory, etc.
Note that when you
COPY
COPY
completely overwrites anything in the existing model memory, including
MODEL
NAME
.
The
MODEL
TYPE
function overwrites all data except name and
RX MODUL
.
GOAL of EXAMPLE: STEPS: INPUTS:
Reset model memory 1.
NOTE: This is one of several
functions for which the radio requires
Confirm you are currently using the
proper model memory. (Ex: 1)
number on top left. If it is not correct,
use
MODEL
SELECT
.
Open the menu, then open
MODEL
SELECT
submenu.
for 1 second.
if required to
MODEL SELECT
.
Go to
MODEL
RESET
and reset the
memory.
to
RESET
. for 1 second.
Sure?
displays.
*
Close.
Where next? Now that the memory is reset, name has returned to the default (Ex:
MODEL-0001
).
NAME
the model: p. 29.
COPY
a different model into this memory: p. 27.
SELECT
a different model to edit or delete: p. 27.
Change the
MODEL
TYPE
to airplane or helicopter: see p. 30.
Change the receiver modulation [
SFHSS
or
FHSS
]: see p. 31.
Utilize servo
REVERSE
: see p. 35.
Adjust servo travel with
END POINT
: see p. 36.
Set up dual/triple rates and exponential (
D/R
,
EXP
): see p. 39.
*Radio will show a "complete" and it shows that the reset was completed. Note that if the power switch is turned off prior to completion, the data will
not be reset.