Instruction Manual

31
Receiver modulation select (
RX
): sets the type of modulation transmitted.
The modulation of your receiver will determine whether you utilize
S-FHSS
or
FHSS
setting in
RX
during transmission.


F/S
) settings as you intended (see p. 48).
S-FHSS
/
FHSS

S-FHSS
mode/
FHSS
mode)
Adjustability:

S-FHSS
  
number of channels.

FHSS


NOTE: When you change models in
MODEL SELECT
, if the new model is set to the other modulation type,

to remind you until you do so. See p. 27,
MODEL SELECT
, for details.
Use
R2008SB
by
S-FHSS
mode. Because,
FHSS
has channel restrictions.
GOAL of EXAMPLE: STEPS: INPUTS:
Change model 1 from
S-FHSS
to
FHSS
. Confirm you are currently using the
proper model memory (Ex: 1)

number on top left and the modulation
on top right. If it is not the correct
model, use
MODEL SELECT
, p. 27.
Open the menu, then open
PARAMETER
submenu.
for 1 second.
to
PARAMETER
.
Go to
RX
and change setting.
to
RX
. to
FHSS
.
cycle power 
Cycle power. Cycle power.
Where next? Now that the model is in the proper modulation, the T8J should communicate

Change
MODEL TYPE
to airplane/helicopter: see p. 30.
Set
F/S
settings for when
2.4G
receiver sees interference: see p. 48.
Utilize servo
REVERSE
: see p. 35.
Adjust servo travel with
END POINT
: see p. 36.
Set up dual/triple rates and exponential (
D/R
,
EXP
): see p. 39.