Instruction Manual

34
Model data transmission (
MDL-TRANS
): Transmission of model data is possible with T8J transmitters. Data transfer is
performed on radio.
The present model is
MDL-TRANS
with each transmitter. As for a receiving side, the present model data is rewritten.
*T8J does not carry out normal operation during data transfer.
Always check servo direction prior to every flight as an additional

NOTE:       

GOAL of EXAMPLE: STEPS: INPUTS:
MDL-TRANS
is performed. Open
MDL-TRANS
function.
for 1 second.
to
MDL-TRANS
.
The transmitting side is turned on.
Select
TRANSFER
or
RECEIVE
.
Data is transmitted.
to
Execute
. for 1 second .
Data Trans is for 10 seconds.
T8J of a receiving side is set to
RECEIVE
,
and the same procedure is followed.
The completion of transmission
→
"Complete"
Transmission failure
→
"Failure"
Close.
Where next?
SELECT
a different model to edit or delete: p. 27.
NAME
the model: p. 29.
GOAL of EXAMPLE: STEPS: INPUTS:
Change
BATT TYPE
from
4CELL
to
5CELL
. Open the menu, then open
PARAMETER
submenu.
for 1 second.
to
PARAMETER
.
Go to
BATT TYPE
and change setting.
(Ex:
5CELL
)
to
BATT TYPE
.
to
5CELL
.
Close.