Instruction Manual
54
Dual Elevator Servos (with a rudder) (
AILEVATOR
) (
ACRO
): Many models use two elevator servos, plugged in separate
ELEVON
V-TAIL
, p. 55.)
travel.
surfaces.
Adjustability:
THROTTLE-NEEDLE
uses
REVERSE
or the set percentages may be reversed here.
50%
AIL3
and
4
to
0
disables this feature. Note: if you want this, but controlled with a switch, set
AIL3
and
4
to
0
here, and use
2 mixes .
AIL-to-ELEV
and
AIL-to-AUX2
the assigned switch is on.
The
AILEVATOR
mixing function uses one servo on each of the two elevators, and combines the elevator function with the
aileron function (unless aileron travel is set to
0
another in conjunction with the ailerons.
Once
AILEVATOR
is activated, unless you zero out the aileron values (see below), any time you move your ailerons or any
servos to also operate as ailerons. To deactivate this action, simply set the 2 aileron travel settings to
0
in the
AILEVATOR
GOAL of EXAMPLE: STEPS: INPUTS:
Activate twin elevator servos.
ailerons portion of this function.
geometry, you may need to reverse one
servo or set a negative percentage here.
Open the
AILEVATOR
function.
for 1 second.
to
AILEVATOR
.
Activate the function.
to
MIX
. to
ACT
.
Optional: adjust up/down travel when
0
to
AIL3
. to
0%
.
to
AIL4
. to
0%
.
Optional: adjust total elevator travel
travel to
98%
, left to
96%
to
ELE2
. to
98%
.
to
ELE1
. to
96%
.
Close menu.
Where next?
SUB-TRIMs
: see p. 46 and
END POINTs
: see p. 36.
Set up
AIRBRAKE
mix: see p. 61.