Instruction Manual

55
Using
V-TAIL
(
ACRO
):
V-TAIL

functions are combined for the two tail surfaces. Both elevator and rudder travel
can be adjusted independently on each surface.
NOTE: If
V-TAIL
is active, you cannot activate
ELEVON
or
AILEVATOR
functions. If one of these functions is active, an error
message will be displayed and you must deactivate the last function prior to activating
V-TAIL
.
NOTE

travel until no binding occurs.
Adjustability:


        
RUD1
and
2
to
0
. Next, use two programmable
mixes,
RUD-ELE
and
RUD-RUD
, setting different percentages for up and down. These are your new rudder travels. Trim off

PROG.MIX
, p. 65.)


GOAL of EXAMPLE: STEPS: INPUTS:
Activate
V-TAIL
.
Adjust left elevator servo to
95%
travel

Open the
V-TAIL
function.
for 1 second.
to
V-TAIL
.
Activate the function.
to
MIX
. to
ACT
.
optional: adjust the travels separately

left to
95%

to
ELE1
. to
95%
.
Repeat as necessary for other servos.
Close menu.
Where next? Adjust
END POINTs
: see p. 36 and
SUB-TRIMs
: see p. 46.
Set up dual/triple rates and exponential(
D/R
,
EXP
): see p. 39.
Set up
ELE-FLAP
mix: see p. 59.
