Operation Manual

• Dial as master: To directly effect one servo’s position by moving a dial, set the master as the desired dial.

(Ex: create a second throttle trim on left slider.)

MASTER SLAVE LINK TRIM SWITCH POSITION RATE OFFSET

VR(D) THRO OFF N/A ANY NULL 5% 0

• Slave: the controlled channel. The channel that is moved automatically in response to the movement of the master

channel. The second channel in a mix’s name (ie aileron-to-rudder).

• Link: link this programmable mix with other mixes.

Ex: PMIX FLAP-ELEVATOR mixing to correct for ballooning when flaps are lowered, but model has a V-tail. Without

LINK, this mix only moves CH2 elevator when flap is commanded, resulting in a dangerous combination of yaw and

roll. With LINK ON, mixing is applied to both CH2 and CH4.

MASTER SLAVE LINK TRIM SWITCH POSITION RATE OFFSET

FLAP ELEV ON OFF ANY NULL 5% 0

• Trim: master’s trim affects slave. Not displayed if master is not CH 1-4, because 5-9 have no trim. Ex: two rudder

servos. With TRIM OFF, rudder trim would bind the two servos. TRIM ON resolves this.

• On/off choices:

• S

WITCH: Any of the positions of any of the 8 switches may be used to activate a mix. Up&Cntr, Cntr&Dn options

allow the mix to be ON in 2 of the 3 positions of a 3-position S

WITCH

• NULL: No SWITCH can turn this mix OFF. This mix is active at all times.

• STk-THR: Turned on/off by THROTTLE STICK movement. Trigger point/direction are selectable. Ex: OFST-to-(gear

doors) mix to open gear doors at idle, which is only active if throttle is below half.

MASTER SLAVE LINK TRIM SWITCH POSITION RATE OFFSET

OFST AUX2 OFF NO STk-THR Stick at ½, 100% 0

for 1 sec.

• Rate: the percentage of the slave’s range it will move upon maximum input from the master channel. Ex: RUDDER-

AILERON mix, 50%. Ail range=1”. When rudder is moved full right, ailerons move ½”.

MASTER SLAVE LINK TRIM SWITCH POSITION RATE OFFSET

RUDD AILE OFF OFF ANY NULL 50% 0

• Offset: Offsets the slave’s center relative to the master. Ex: Smoke valve opens wider per throttle servo position when

smoke S

WITCH is ON. Smoke servo’s neutral is moved down from THROTTLE STICK center to the bottom.

MASTER SLAVE LINK TRIM SWITCH POSITION RATE OFFSET

THRO AUX2 OFF OFF E DOWN 100% 100%