Operation Manual

Model Setting Section
CUT—ENGINE CUT
This function may be used to define a switch
setting that may be used to cut the engine. It will
only work when the throttle stick is at the low
side; the throttle position may be set.
When this function is actuated with the throttle
stick below the set threshold, the throttle servo is
commanded to an offset position (there is no
effect above the threshold position). When activat-
ed, the Alarm light flashes to remind you the com-
mand is on.
Airplane
Offset Direction
Helicopter
0 Position
-100%
Slow Side
+100%
Engine Cut Setting Procedure
Activation of command In the Model Menu, press the
CUT key to get the Engine Cut menu.
Function State Display (ON/OFF)
Mode Setting
Throttle Position
Setting
Offset Throw Setting
ON/OFF
Switch Setting
Return to
Model Menu
Mode Selection
Use the
A key to activate mode setting, then press
the ACT or INH keys (F and G) to activate or
inhibit the engine cut command.
Threshold Setting Now you will set the throttle posi-
tion that the engine cut command will operate under-
neath: press the B key to activate position setting, place
the throttle stick in the desired position, and then use the
SET (F) key to enter the position into memory. If
the throttle stick is above this position, CUT will not
occu r.
Throttle Servo Offset Setting You now set the amount
and
direction of throttle servo throw. Press the C right-
arrow key and set the rate with the numeric keys. The
number keys (0) through (
100 ) input the value
directly. The ( + ) and ( - ) keys increase or decrease
the value by 1. The +/- key may be used to reverse the
offset direction.
Setting the Engine Cut Command Switch Call the
Switch Setting screen by pressing the
SWT ( P ) key.
Set the desired switch using the instructions on page 37.
When complete, press the PRE button (N) to return
to the previous screen. Use the END ( N ) key to leave
this menu.
Model Setting Section, Page 47