User Manual

ManualsBrandsFutaba ManualsHardwareDT1 Tach

FUTABA FP-DT1 TACHOTIMER INSTRUCTION MANUAL

SPECIFICATIONS:

Dimensions 2.5x6.1x9.9” 64x155x22.5mm

Weight: 4 oz 115g (without battery)

Power: 3.0v (2 AA batteries)

Current Drain: 1mA

Display: LCD, 4 digit

Integrating Meter 0-60 hours (minimum units displayed: min.)

Up Timer 0-60 minutes (minimum units displayed: sec.)

Down Timer 60-0 minutes (minimum units displayed: sec.)

Oper. Temp Range: 32 to 104°F 0 to 40°C

Storage Temp Range: -4 to 131°F -20 to 55°C

Functions:

• Tachometer 2 blade propeller specifications

! Low Range: 100 to 30,000 RPM

o Error +/- 100 RPM

! High Range: 100 to 60,000 RPM

o Error +/- 200 RPM

Features:

• Built-in microprocessor

• Four functions

• Alarm

• Low current drain

• Long battery life

Summary of content (4 pages)

PAGE 1
FUTABA FP-DT1 TACHOTIMER INSTRUCTION MANUAL SPECIFICATIONS: Dimensions 2.5x6.1x9.9” Weight: 4 oz Power: 3.0v Current Drain: 1mA Display: LCD, 4 digit Integrating Meter 0-60 hours Up Timer 0-60 minutes Down Timer 60-0 minutes Oper. Temp Range: 32 to 104°F Storage Temp Range: -4 to 131°F Functions: • Tachometer ! ! 64x155x22.5mm 115g (minimum units displayed: min.) (minimum units displayed: sec.) (minimum units displayed: sec.
PAGE 2
NOMENCLATURE AND FUNCTIONS: ON THE LEFT SIDE: • REV RANGE switch selects RPM range o Low Range: 100-30,000 RPM • Error +/- 100 RPM o High Range: 100 to 60,000 RPM • Error +/- 200 RPM • INTEG TIME switch o starts (COUNT) and stops (HOLD) • POWER switch • ON THE RIGHT SIDE • MODE SEL push button scrolls through and selects: o INTEGRATING TIMER o UP TIMER o DOWN TIMER o TACHOMETER o Press MODE again to return to INTEGRATING TIMER. • TIME SET switch sets the alarm time when used as an UP or DOWN timer.
PAGE 3
OPERATING INSTRUCTIONS: • INTEGRATING TIMER: 1. INTEG TIME switch set to: ! COUNT: timer counts. Arrow blinks next to IT. ! HOLD: temporarily holds the counter. ! When set to HOLD, counting stops but setting is remembered. When switched back to COUNT, continues counting. 2. ENTER push button used to: ! BEGIN count if not currently counting. ! CLEAR the integrating timer setting. 3. DISPLAY: indicates the time in hours:minutes. If the display shows 0:03, three minutes have elapsed.
PAGE 4
• Do not subject the timer to severe shock.