User's Manual

p.7FUTABA
Ni04-009-1 rev5.0
3-3. Connecting feeder cables to the terminator unit
Please follow the next procedures and also refer to the related figure.
a Remove the six screws on top of the terminator unit to open the unit cover.
)
b Turn the two screws that are located in center of one of the terminal pads so that metal wire of a
)
feeder cable can fit in.
c Turn the screws of the cable holder made of black resin.
)
d Insert a feeder cable into a hole of the chassis and then insert the two bunches o f conductive wires of
)
the feeder cable separately into the two holes in the terminal pad.
Please make sure that twisted wires do not loosen and touch the neighboring wires. If a single wire
of a bundle touches the other bundle, communication cannot be established.
e Tighten the two screws on top of the terminal pad.
)
f Tighten the screws of the cable holder made of black resin.
)
g After confirming that screws are firmly tightened, cover the top chassis and tighten the six screws.
)