User's Manual

32
REG16: Terminator 1 [default value: 0DH]
• Set an arbitrary 1 byte terminator. In case of a 2-byte terminator, set the first byte
character of the terminator.
REG17: Terminator 2 [default value: 0AH]
• Set another arbitrary 1 byte terminator. In case of a 2-byte terminator, set the last
character of the terminator .
REG18: Communication Setting 1 [default value: 8CH]
Bits 7 – 6: Protocol
bit 7
bit 6
Setting
0
0
Data transpalent mode
0
1
Reserved
1
0
Packet transmission mode
1
1
Headerless stream mode
Table 5–7: Protocol
Bits 5: Reserved
• The FDL01TU does not use this register. Keep the default value as it is.
Bit 4 Transmission format
0
transmit in the text form (default value)
1
transmit in the binary form
Table 7–4 Transmission format
• Selects the transmission format. When data are transmitted to the destination
station which is set to the normal packet transmission mode, output text format
(RXT, RBN) from the receiver modem (destination station) differs depend on this
setting.
• This setting does not effect in the receiver modem set as headerless stream mode.
Bits 3 – 2 Terminator Setting
bit 3 bit 2
setting
0 0
two kinds of arbitrary 1 byte code (REG16, REG17)
0 1
arbitrary 1 byte code (REG16) ＋ a wild card (any character)
1 0 arbitrary 2 byte code (REG16 + REG17)
1 1
carriage return (CR) ＋ line feed (LF) (default value)
Table 7–5 Terminator setting