User's Manual

46
CON Connect Wireless Link
Syntax
CON(destination address)
destination address : 000 to 999
Response
P0 : connection established
P1 : command received, link established
N0 : command error
N1 : connection failed – no response from destination modem
N4 : connection failed – local modem already connected to a remote
modem.
Function
Requests a wireless link connection to the remote modem in data transparent mode.
If this command is input with no destination address parameter, the destination will
be the address that was set with the REG02.
If the destination address is input, change the destination address to connect the
wireless.
Example
>
@ DAS002 ↵ : set the destination address to 002
<P0
↵ : connection established
>
@ CON ↵ : request wireless connection remote station 002
<P1
↵ : connecting…
<P0
↵ : connection established
(Time-Division-Duplex communication between terminals is established.)
>
@ DCN ↵ : request disconnection of the wireless link
<P1
↵ : disconnecting…
<P0
↵ : connection established
>
@ CON003 ↵ : request wireless connection to remote station 003
<P1
↵ : connecting…
<P0
↵ : connection established
>
@ CON004 ↵ : request wireless connection to remote station 004
<N4
↵ : local modem already connected to a remote modem
Notes
If this command is input to designate the destination address, the destination address
set with the DAS command will be changed to set the address designated with this
command to the designation address.
DAS Reference and Set Destination Address
Syntax
DAS(set destination address)
set destination address : the desired destination address (000 to A23)