User's Manual

48
DCN Disconnect Wireless Link
Syntax
DCN
Response
P0 : connection established
P1 : command received, link disconnected
N0 : command error
N1 : link disconnect failed
N4 : link is disconnected
Function
In data transparent mode, this command requests wireless disconnection from the
remote modem.
Example
>@CON002
↵ : request wireless connection to station 002
<P1
↵ : connecting…
<P0
↵ : connection established
(Time-Division-Duplex communication between terminals is established.)
>
@ DCN ↵ : request disconnection of the wireless link
<P1
↵ : disconnecting…
<P0
↵ : connection established
>
@ DCN ↵ : request disconnection of the wireless link
<N4
↵ : link is disconnected
FRQ Reference and Set Frequency Group
Syntax
FRQ(:frequency group){Local Station Address}
frequency group : combination of frequency grouping method (A to
H) and group number (00 to 75). See p.18
F REQUENCY G ROUPING more details.
Local Station Address : local station address for 485 mode (000 to A22) .
Response
xxx : current value
P0 : command accepted
N0 : command error (Except 485 mode)
Function
References or sets the frequency grouping method and group number.
The current set value is referenced by omitting the “:frequency group” parameter
This command is for temporary use only. To change the default value, change the
settings of REG06.