User's Manual

55
This function is used to save the current consumption when no transmit/receive are
required.
Example
>
@ ROF CR/LF : turn off RF circuit block
<P0
CR/LF : command accepted
>
@ RON CR/LF : turn on RF circuit block
<P0
CR/LF : command accepted
RON RF Circuit Block Power Up
Syntax
ROF{Local Station Address}
Local Station Address : local station address for 485 mode (000 to A22).
Response
P0 : command accepted
N0 : command error (Except 485 mode)
Function
Turn on the power of RF circuit block and activates RF operation.
Use this command to activate RF circuit block after its power down state set by
the ROF command.
The status when the modem is powered ON or reset, the RF circuit block is in the
operation state.
Example
>
@ ROF CR/LF : turn off RF circuit block
<P0
CR/LF : command accepted
>
@ RON CR/LF : turn on RF circuit block
<P0
CR/LF : command accepted
RST Reset
Syntax
RST{Local Station Address}
Local Station Address : local station address for 485 mode (000 to A22).
Response
P0 : command accepted
N0 : command error (Except 485 mode)
Function
Resets the modem to restore the power on state.
When any memory register is rewritten with REG command before issuing this
command, the value rewritten becomes valid and active. Temporary settings like
DAS and FRQ command become invalid and the memory register settings is
loaded.