User's Manual

Ver.1.0
31
DAS (Show/set the destination address)
[Format]
DAS (setting value)
setting value: 000 to 255
[Response]
xxx: Current address (in case of address referencing)
P0: Normal end (in case of address setting)
N0: Command error
[Function]
- This command shows and/or sets the
destination address of headerless packet transmission mode.
- When this command is entered without any setting values, the FDP03 returns current destination address.
If setting value (new address) is put after DAS command, the destination address of the FDP03 is changed
to new one.
- Setting of a new address by this command is temporary. If the FDP03 is reset by RST command or
initialized, the destination address is returned to the address that is defined by REG02.
[Examples of use]
>@DAS<Cr><Lf>: Show current destination address
<003<Cr><Lf>: Current destination address is “003”.
>@DAS001<Cr><Lf>: Set the destination address to “001”.
<P0<Cr><Lf>: The destination address is changed normally.