User's Manual

Ver.1.0
37
RST (resetting the FDP03)
[Format]
RST
[Response]
P0: Normal end
N0: Command error
[Function]
- This command has the following two functions:
(1) If values of the memory registers are changed before this command is executed, new register settings
are registered by this command execution. However, values that are changed by “DAS”, “FUN”
and “FRQ” command are vanished and the settings of memory registers are effective.
(2) This command also makes the FDP03 exit from the line quality test of the “TS2” command. When
this command is executed for exit from the line quality test, the memory register settings that are
made before execution of the TS2 command are not saved.
[Example of use]
>@RST<Cr><Lf>: This command resets the FDP03.
<P0<Cr><Lf>: This response indicates the normal end of command processing.
The host cannot receive any response from the FDP03 if
communication parameters such as baud rate are different from default
setting.
It will take 520ms at maximum for P0 response of this command.
Memory registers may get damages if the power of FDP03 is turned
off before the P0 response comes back.